The Thermometer; The Back Light - Oregon Scientific OUTBREAKER RA201 User Manual

Refer to Fig 5f for TIMER 2 and TIMER 3 display mode.
Timer 1 -Chronometer
FUNC
FUNC
Fig.5f
Notes:
a) During count down the timer minute can be increased or decreased
to the full counting minute.
b) When reaching every full minute there will be a short double
beeping sound.
c) When countdown time reaches 5 minutes, there will be short
double beeping sound for 5 sec.
d) When countdown time reaches the last minute, there will be
continuous beeping with 1 second on and 1 second off cycle.
e) For the last 5 seconds of the countdown there will be a
continuously beeping sound.
f) At the completion of the countdown there will be a long beeping
sound for indication.
g) After completion of the countdown, it will automatically activate
the stopwatch.
h) The maximum stopwatch range will be 99:59:59.
i) When the timer or stopwatch stops or after a reset, it will resume
to 10 minutes for timer 2 or 6 minutes for timer 3.
Timer 2 - 10 min Timer 3 - 6 min
+ - +
sailing timer sailing timer
FUNC FUNC
j) At the bottom of the display a running icon shows the status.
-

THE THERMOMETER

RA201 is equipped with a thermometer. Please refer to section
CALENDAR CLOCK MODE, ZONE TIME AND UNIT OF MEA-
SUREMENT; INFORMATION SHOWN IN ALTIMETER; and
INFORMATION SHOWN IN SAILING TIMER MODE.
Notes:
• When RA201 is worn on wrist, the temperature measured could
be affected by the body heat. To acquire an accurate temperature
reading, remove RA201 from the wrist and wait at least for 15
minutes before taking the reading.
Press LIGHT to turn on the backlight for five seconds.
Notes:
a) When the backlight is ON, any key press will keep it ON for an
additional five seconds.
b) The backlight will not switch on when the battery level is too
low. This indicates a need to change the battery.
c) If [ ] appears, the backlight function will deactivate in order
to save the battery power.
19

THE BACK LIGHT