Table of Contents
Advertisement
B) SET ALARM CLOCK BY PC SOFTWARE
The alarms may also set through the PC software. To connect the
watch to the PC software please refer to Section 7.
HOW TO USE THE CHRONOMETER
When the chronometer is displayed, use START/STOP to start or
stop a count up. Pressing the same button after stopping the count up
will clear the chronometer. Refer to fig 5 for the operation.
Note:
Chronometer could be activated in various modes, please also refer
to Section 3 –6.
HOW TO USE THE TIMER
Refer to fig 6 to set the timer.
To start the timer, press START/STOP. To stop, press the button
again. Press the same button a third time to resume the count down.
Refer to fig 7 for the operation.
Note:
When the timer reaches the preset time, it will count up as a
chronometer automatically.
THE THERMOMETER
Your OUTBREAKER is equiped with a thermometer. Refer to Fig
2 to display the temperature in clock mode.
Note:
a) When the OUTBREAKER is worn on wrist, the temperature
measured could be affected by the body heat. To acquire an
accurate temperature reading remove the OUTBREAKER from
the wrist and wait at least for 15 minutes before taking the
reading.
b) The temperature could also be displayed in various modes,
please also refer to Section 3 - 4.
SECTION 3 THE ALTIMETER
This section applies to all models.
Your OUTBREAKER is equipped with an intelligent barometer that
helps determine altitude by the built-in sensor with the advanced
Barocompensation technology. The sensor can also distinguish the
differences between pressure caused by changes in physical altitudes
or pressure caused by weather conditions. This smart distinction
eliminates discrepancies and makes the altimeter reading more
accurate than the average devices.
6
Advertisement
Table of Contents
