Installation Instructions; Prepare Cooktop For Installation; Install Cooktop; Make Electrical Connection - KitchenAid KECC548BSS0 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.
1. Using 2 or more people, place the cooktop upside down on a
covered surface using the foam end posts from the
packaging.
2. Insert the mounting clips (provided) into the 4 pockets along
the sides of the metallic frame under the glass top.
Cooktop Over Undercounter Built-In Oven
1. Using 2 or more people, place cooktop right side up into the
cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
Insert bottom of mounting clip into bottom of pocket
and push top over top of pocket to snap into place.
.......... _;::,;,==_,,, ,,_ =_,, 0 II I](!!CI'101}
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This cooktop is manufactured with a frame connected, green or
bare ground wire. Connect the cooktop cable to the junction box
through the UL listed or CSA approved conduit connector.