Table of Contents
Advertisement
22
7. Auxiliary Functions
Interrupt
The Interrupt function allows you to interrupt a
current job and run a different one. Pressing
the Interrupt key once sets the copier into the
Interrupt mode. Pressing the key again lets
copier leave the Interrupt mode, returning to
the previous settings.
Useful Tips
If the current job involves 2-sided
copying, Cover function, Pages Insertion
or OHP Interleaving, the copier rejects
an Interrupt cycle.
If the current job involves a finishing
function other than Non-Sort, Non-Sort is
automatically selected at the same time
when an Interrupt function is invoked.
Mode Check
By pressing the Mode Check key on the
control panel, you can either check for or
change the current settings.
When you touch [Exit] after having checked
the currently set functions, the Basic screen
reappears.
To change a certain function, touch the
corresponding key and then make the
necessary change.
Access Number
If an access number has been programmed, it
allows only particular persons to use the copier
or a supervisor to keep track of the number of
copies made by a particular department..
Entering the Access Number
1
1149O259CA
2
3
NOTES
If an access number has been
programmed, a copy cycle can be
initiated only after the access number
has been input to the copier.
<"Access #" Prompt Screen>
Before you can use this function, you
must first turn "ON" the "Copy Track"
function of the Administrator Mode
available from User's Choice.
From the 10-Key Pad, enter the 4-digit
access number and press the Access
Mode key.
1
2
3
4
5
6
7
8
9
0
C
NOTE
To correct the 4-digit access number
entered, first press the Clear key, then
enter the new number.
When the initial screen reappears, you
can now start a copy cycle.
When the copy cycle is completed,
press the Access Mode key again.
1149O271CA
p. 88
1134P438DA
1134P438DA
Advertisement
Table of Contents
