Table of Contents
Advertisement
2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which meets
the following requirements.
A place away from a curtain or the like that
may catch fire and burn easily.
An area where there is no possibility of being
splashed with water or other types of liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air
conditioner, heater, or ventilator.
A well-ventilated place.
A dry place.
Power Source
The power source voltage requirements are as follows.
Use a power source with little voltage fluctuation.
Voltage Fluctuation
Frequency Fluctuation : Within 0.3%
Space Requirements
To ensure easy copier operation, supply replacements and service maintenance, adhere to the recommended
space requirements detailed below.
* Be sure to allow a clearance of 150mm (6 inch) or more at the back of the copier as there is a ventilation duct.
EP1031F (with Semi-automatic Document Handler)
101 (4)
EP1031 (with Original Cover)
660 (26)
101 (4)
: Within 10%, (+6%, -10% (Only AC127V))
921 (36 1/4)
837 (33)
660 (26)
559 (22)
291 (11 1/2)
921 (36 1/4)
837 (33)
559 (22)
291 (11 1/2)
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
A place where ammonia or other organic gas
is not generated.
A place which does not put the operator in the
direct stream of exhaust from the copier.
A place which is not near any kind of heating
device.
804 (31 3/4)
304 (12)
500 (19 3/4)
87°
849 (33 1/2)
304 (12)
545 (21 1/2)
105°
Unit: mm (inch)
49 (2)
C1159O002DA
94 (3 3/4)
C1159O003DA
Hide quick links:
Advertisement
Table of Contents
