Table of Contents
Advertisement
2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it
in a location which meets the following requirements.
A place away from a curtain or other things that catch fire and burn easily.
An area where there is no possibility that it might be splashed with water or
other liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air conditioner, heater, or ventilator.
A well ventilated place.
A dry place.
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
Power Source
The power source voltage requirements are as follows.
Use a power source with little voltage fluctuations.
Voltage Fluctuation
Frequency Fluctuation
If any other electrical equipment is sourced from the same power outlet, make
sure that the capacity of the outlet is not exceeded.
The outlet should be located near the machine and easily accessible.
Never connect by means of a multiple socket any other appliances or machines
to the outlet being used for the copier.
If an extension cord is needed, use one with a capacity more than the power
consumption of the copier.
Make sure that no unusual, excessive force is being applied to the power cord
or extension cord.
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always
ground the copier.
Connect the grounding wire to:
The ground terminal of the outlet.
A grounding contact which complies with the local electrical standards.
Never connect the grounding wire to a gas pipe, the grounding wire for a
*
telephone, or a water pipe.
: Within 10%
: 50/60 Hz Within
Advertisement
Table of Contents
