Making Copies - Minolta CSPRO EP1031 Manual

12

1. Making Copies

The basic copy made is one that is the same size (100%) as the original.
In this procedure, the copy is positioned (Step 1), the number of copies is set (Step 4), the Start Key is
pressed (Step 5) and a copy is made that has the same size of paper as the original.
(* In the initial mode, auto exposure and 100% zoom have already been selected.)
Following the steps shown, various adjustments to exposure and zoom ratio can be made.
1. Position the original.
Open the cover and place the original face
down on the glass. (See page 13.)
To change zoom
ratio
To change image
density.
4. Set the number of copies to be made.
Use the Copy Quantity keys to set the number of copies to be made. (See
page 15.)
* If the original has been placed in the Semi-automatic Document
Handler (SDH), the display will automatically show the number "1".
* To clear a wrong setting, press the Clear/Stop Key and then make the
setting once again.
5. Press the Start Key.
Press the start key and copying will begin.
* Press the Clear/Stop Key to interrupt continuous copying.
Copying will automatically stop.
C1159O013DA
2. Press the Copy Quantity/Zoom Selection Key
and select the zoom ratio with the Fixed
Zoom Ratio Key. (See page 17.)
* The zoom ratio cannot be
changed while the SDH
mode is used.
(The setting remains at 100%.)
3. Use the Exposure Control Keys 46 to adjust
image density. (See page 16.)
[Only for units equipped with the
Semi-automatic Document Handler (SDH)]
Place the original in the SDH. (See page 14.)
C1159O014DA
C1159O009EA
C1159O016DA
C1159O017DA
C1159O018DA