GE ZISS480NXBSS Installation Instructions Manual page 17

Side by side refrigerators
Hide thumbs Also See for ZISS480NXBSS:
Table of Contents

Advertisement

Installation
Instructions
ISTEP 12AI (continued)
Custom
Handles
• If gou are using custom handles, the handle must
be praperlg
secured to the overlag
panel before sliding
the panel into the trim.
• The cabinet manufacturer
will supplg the custom
handle and hardware.
• Discard the supplied handle.
Reinstallall original screws.
• Reinstall the handle side trim, using all 12 supplied
flat-head screws, plus the 12 flat-head screws
originallg installed in the handle trim.
• Install a supplied end cap onto the top of the door,
using a Phillips head screwdriver and the 2 screws
provided. Hand-tighten
the screws into the end caps.
Do not overtighten;
damage will occur.
• Clean the aluminum trim with rubbing alcohol-
do not use alcohols with oil or lanolin that will prevent
adhesion of double-sided tape.
• Slip the aluminum cover trim behind the top end cap
to check the fit. The aluminum cover trim has a recess
on each end which fits the end cap.
CoverTrim
TopEndCapFits Over
InsertAluminum
the AluminumTrim.
TrimInto EndCap.
SecureCapwith
2 Screws.
• Remove the trim. Peel awag a few inches
of the adhesive backing.
IMPORTANT:The tape is very sticky and strong. Once
it adheres to a surface, it cannot be removed without
damaging both surfaces. Do not install the trim before
the final wood panels are in place. Be sure to align
the trim carefully before removing the paper backing.
ISTEP 12AI (continued)
• Carefully
place the aluminum
cover trim into top
end cap so that the recess is aligned with the cap.
Use the top to bottom
grooves
along the handle side
to align the cover trim accurately.
Pull the tape a few
inches at a time while pressing the trim against
the doon Press and hold approximately
10 seconds
before continuing
along the length of the doon
• Install another end cap at the bottom
of the door
to secure the cover trim. Use a stubby
Phillips head
screwdriver
and the 2 screws provided.
NOTE: Make sure there are no gaps in the installation.
• Follow the same procedure
on the opposite
daan
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents