Step 13, Install Dispenser Trim; Step 14, Connect Water Supply - GE ZISS480NXBSS Installation Instructions Manual

Installation Instructions
[STEP 13] INSTALL DISPENSER TRIM
Skip this step is gou are installing a stainless steel
wrapped or a non-dispenser refrigerator,
There are two dispenser trims shipped with gour
refrigerator. Select the appropriate trim for gour
application.
Compare the dispenser trims. Note that
the inside depth of the frames are different,
Choose the trim with less depth for framed
panels, choose the deeper one for overlag
panels.
Dispenser trim fit over the custom panel depends on
correct panel thickness. See pages 7 and 8 for panel
construction information.
• Press and snap the dispenser trim into the dispenser
recess on the refrigerator door.
If an excessive gap exists around the dispenser trim
or if the panel fits Ioosel 9 in the door frame, foam tape
may be applied to help improve the fit. Remove
the trim and panel and applg the foam tape
to the door around the dispenser and in the corners.
ISTEP 14] CONNECT WATER SUPPLY
• Locate and bring the tubing to the front
of the cabinet.
• Turn the water on to flush debris from the line.
Run about a quart of water through the tubing
into a bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both ends of
the copper tubing. Insert the tube into the union fitting
on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
GE SmartConnect T"Tubing:
• Insert the molded end of the tubing
into the refrigerator connection. Tighten
the compression nut until it isjust hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check far leaks.
NOTE: Hake sure excess tubing length does not
interfere with the toekick installation.
18