Kyocera FS-6025MFP/B Operation Manual page 306

Troubleshooting > Solving Malfunctions
Symptom
Cannot print with USB
memory.
USB memory not recognized.
When displaying an image
sent from the machine on the
PC, an image size is shrunk
vertically or horizontally.
Black or white vertical streaks
Dirt on the top edge or back
of the paper
Part of the image is
periodically faint or blurred.
White spots appear on
image.
Print on the back of the sheet
is visible on the front.
Checkpoints
Is the USB host blocked?
Check that the USB memory is
securely plugged into the machine.
Have you selected 200×100dpi Normal
or 200×400dpi Super for the scan
resolution?
s the slit glass dirty?
Check the operation panel for toner.
Check the paper chute and the ramp.
Have the developer unit and drum unit
been loaded properly?
Is the right cover completely closed?
—
—
—
Corrective Actions
Select Unblock in the USB host
settings.
—
Select a scan resolution other than
200×100dpi Normal or 200×400dpi
Super when sending an image.
Clean the slit glass.
If the Toner is empty message is
displayed, install a new toner
container.
Open the right cover and check for
toner on the paper ramp inside the
paper transfer unit. Clean the paper
ramp using a soft, dry, lint-free cloth.
Load the developer unit and drum unit
properly.
Close the right cover.
Run [Drum Refresh 1].
If you experience frequent problems,
turn the cassette heater switch on.
Run [Drum Refresh 2].
Set Prevent Bleed-through to [On].
10-10
Reference
Page
9-21
—
3-50
10-6
10-2
—
—
—
9-24
2-4
9-24
3-54