Naming And Storing - Kurzweil PC2R Musician's Manual

Naming and Storing

Storing (saving) is optional, of course. If you don't want to store any of your changes, press
Cancel one or more times to return to the mode you were in before you started editing.
Although naming is obviously optional as well, we'll assume you're going to name the object
you're editing before storing it.
This procedure describes storing a setup, so it assumes that you're in MIDI Setups mode. The
process is similar for naming and storing other objects.
1. Press Store (in the Functions group of buttons). The display will show either
Save|Setup|NNN?
• If you're in the Internal bank of setups, the display will show
where
• If you're in the User bank, the display will show
is the ID of the current setup. Use the Alpha Wheel to change the ID if you want to
save a new setup instead of replacing the current one.
2. Press the Right cursor button to display
3. Press Yes (Enter). The display shows the name of the current setup, if any. The cursor
highlights the character that's selected for editing.
4. Use the Alpha Wheel to change the character highlighted by the cursor. Use the cursor
buttons to move the cursor.
5. When the name looks the way you want it, press Yes. The display again shows either
Save|Setup|NNN?
you started storing.
6. Press Yes (or press No if you don't want to store the setup after all). The display briefly
shows Setup|NNN|saved!
Special Characters For Naming Objects
Here are all the characters available for object names, in the order in which they appear:
! " # $ % & ' ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9
: ; < = > ? @ A through Z
[ \ ] ^ _ ' a through z (space)
When you're naming objects, you can press Zone 1 to switch a letter from upper to lower case,
or vice versa. Press Zone 2 to insert a space at the cursor, moving the remaining characters to the
right. Press Zone 3 to delete the character at the cursor, moving the remaining characters to the
left. Press Zone 4 to move the cursor to the end of the name.
or Replace|Setup|NNN?
is the first available setup ID in the User bank of setups.
NNN
or
Replace|Setup|NNN?
then returns to MIDI Setups mode.
where NNN is the setup ID.
Replace|setup|NNN?
Rename|setup|NNN?
, depending on where you were when
Programming Your PC2R
Basic Editing Concepts
Save|setup|NNN?
where
NNN
4-3