No Sound - Kurzweil PC2R Musician's Manual

Startup
Powering Up

No Sound

If no sound comes from the audio or headphones outputs of your PC2R when you play your
MIDI control source, check the following:
• The Volume knob might be set too low.
• Your MIDI connection may not be functioning: check that you have a MIDI cable connected
from the MIDI Out port of your MIDI source to the MIDI In port of the PC2R. The LED in
the MIDI Receive button blinks when the PC2R receives MIDI information.
• Your MIDI source may not be sending MIDI information.
• The channel on which you're sending MIDI may be inactive in the PC2R: Press the
MIDI Receive button; use a cursor button or the Alpha Wheel to select the channel that
your MIDI source is using; use a cursor button to select the Channel On/Off parameter; turn
the Alpha Wheel to the right to change the value to On.
• There may be no current program or setup selected (the display shows
• If your MIDI source has a continuous pedal, check the connection, and check the position of
the pedal.
• You might be in MIDI Setups mode with all zones muted (inactive): press any or all of the
four buttons labeled Zone 1–Zone 4, and the lights in the buttons will turn green.
You could also try the "Panic" feature, which sends an All Notes Off and All Controllers Off
message to the PC2R. Press the KB3 and MIDI Setups buttons at the same time.
2-6
Not|Found ).