Putting Into Operation; Additional Handle - KRESS HAMMER DRILL Original Instructions Manual

Operation
1st n = Idle speed (1st gear)
0
2nd n =Idle speed (2nd gear)
0
1st n = Load speed (1st gear)
1
2nd n =Load speed (2nd gear)
1
in rpm
Individual impact strength in Joule
Number of impacts n
Corner dimension in mm
Collar diameter in mm
Weight in kg
Your device is fitted with an SDS-plus
automatic locking device.
Your device has a manual SDS-plus
locking device.
Drilling and hammer drilling in con-
crete - max. ø in mm
Drilling and hammer drilling in brick -
max. ø in mm
Drilling and hammer drilling in sand-
stone - max. ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
mm
Drilling in wood - max. ø in mm
Your power tool is doubly insulated in
compliance with EN 60745; there is
thus no need for an earth wire.
The machine is radio and TV interference-free in
accordance with EN 55014-1 and interference-
proof in accordance with EN 55014-2.
4. Operation

Putting into operation

-1
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.

Additional handle

Place the additional handle 3 in the working posi-
tion to provide a safe and fatigue-free working sit-
uation.
Tighten the lower hand grip of the additional han-
dle 3 by turning in a clockwise direction. Turn the
hand grip in an anticlockwise direction to release it.
Before carrying out any work on the
machine, pull the mains plug.
Observe correct main voltage!
Fit the additional handle
Connect mains cable module if necessary
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
Operate the machine only with the ad-
ditional handle
Loss of control can cause personal in-
jury.
English 17
cables specifically
BH-EN / 0907
EN