Operation - KRESS KU370.2 Manual

personnel can assist you and offer advice.
OPERATION GUIDELINES
Note: Please read the instructions carefully
before use.
USAGE
This tool is used to screw or drill holes in wood, metal,
plastic and to drill holes in lightweight concrete or brick
walls.
INSTALLATION AND OPERATION
STEPS
BEFORE OPERATION
12
Disassemble battery pack
Battery pack charging
Installation of battery pack
INSTALLATION
CHUCK ADJUSTMENT
Warning: When replacing accessories, make sure that
the power supply is cut off and the switch is turned off
(the reversing lever is in the middle position). When starting the
tool, make sure that there is no hidden danger to the drill bit.
Damage or loosening of the chuck may cause personal injury.
Drill bit disassembly
Installation of drill bit

OPERATION

Forward and reverse switching
Warning: The direction of rotation
can not be changed until the machine
is completely stationary.
SPEED SHIFT
TORSION ADJUSTMENT
Torque selection
The tripping torsion corresponding
PICTURES
to position 1 is the smallest, and that
corresponding to position 20 is the largest.
See Figure A1
Mode switch
Screw batch mode
See Figure A2
Drilling mode
See Figure A3
Hammer drill mode
lightweight concrete and brick walls)
Start/stop
Warning: Do not use start-stop
switch for long time and low speed
operation, otherwise the machine may
overheat and cause tool damage.
See Figure B1
See Figure B2
See Figure
C1,C2,C3
See Figure D
See Figure E
See Figure F
(drilling on
See Figure G