Installation Requirements; Tools And Parts - Kenmore 66513342K606 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation. Read and
follow the instructions provided with any tools listed here.
Tools Needed
• Pliers
• Phillips screwdriver
• Flat-blade screwdriver
• 3/le" and 1/4" nut drivers or hex
sockets
• Measuring tape or ruler
• 11/2'' hale saw bit
• 10" adjustable wrench
• Utility knife
• Level
• Cordless drill
• 1/8" drill bit
• Security T-20 TORX ®f driver (on
some models)
Parts Needed
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. Appropriate sized UI Listed wire connectors _2)
1-®TORX is a registered trademark of Acument Intellectual Properties, LLC
Parts Supplied
Check that all parts are included.
A ..............
!
A. 3/4" UL / isted/CSA Approved strain
re//ef
B, ].25" hose c/amp
C. Mounting bracket screws _8)
D, Unit mounting screws _4)
E. Drain hose connector
F, Mounting brackets _4t)
6;. Drain connector spring clamps _2]
_ C
j ..........
H. Trim strips (2)
L Toe kick brackets (2)
], Toe kick bracket screws (2)
K. Toe kick trim
L. Pane/fasteners (on some mode/s) (2)
A4. TOR._ _ screws (on some mode M (I0)
N. Drain hose