Installation Requirements - Kenmore 66517722K900 Installation Instructions Manual

iNSTALLATiON REQUIREMENTS
Tools and materials needed:
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
o Pliers
o Small hammer
Parts supplied:
o Faucet adapter kit, Part No. 3374592
o 4 casters
o Literature package
Make sure all these parts were included in the dishwasher. Close
and latch dishwasher door. See parts list for accessories available
for your dishwasher.
Location Requirements:
Check location where dishwasher will be used.
The location must provide:
,, Sink or laundry tub that can drain water at a minimum carry-
away capacity of 7 gallons (26 liters) per minute.
,, Top of sink or laundry tub that is at least 27 inches (68.6 cm)
high and not higher than 48 inches (122 cm) from the bottom of
dishwasher.
,, Floor support for dishwasher weight of 180 pounds (81.6 kg).
,, Grounded electrical outlet.
,, Hot water faucet or hot and cold single-spout water faucet within
30 inches (76.2 cm) of the back of dishwasher.
Water supply requirements:
You must have:
, A hot water line with 20-120 psi (138-862 kPa) water pressure.
,120°F (49°C) water at dishwasher.
Electrical requirements:
Contact a qualified electrician.
Assure that the electrical installation is adequate and in
conformance with all national and local codes and ordinances.
You must have:
,, 120-volt, 60 Hz, AC-only, 15 or 20 amp., fused electrical supply.
,, Mating grounded electrical outlet.
We recommend:
,, A time-delay fuse or circuit breaker.
,, A separate circuit, serving only this appliance.
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1. Put two corner posts (A) on the floor behind the dishwasher.
2. Grasp sides of dishwasher door frame (B) and put dishwasher
on its back.
B
3. Firmly push casters (C) into holes at corners of dishwasher as
shown. Pull on each caster to check that casters are snug.
NOTE: It may be helpful to place a piece of wood against the
caster wheels and lightly tap the wood with a hammer.
I incorrect