Whirlpool CET8000AQ1 Installation Instructions Manual page 37

ELECTRONIC CONTROL SETUP INSTRUCTIONS
Code
F. O0
F. O0
F. CP
Explanation
J, C
J, d
J. Ed
ENHANCED PRICING OPTION (WASHER}
Not Selected "OFR"
Cycle-Based pricing enabled. This option allows
configuration of different prices for cold, warm,
and hot water cycles.
• Press the lower-right (COLD) button for this
selection.
Press the lower-middle (WARM) button once to
advance to next code.
J. Cd PAYMENT MODE (COIN/DEBIT OPTION}
J. Cd Both coin and debit selected. Press the
lower-right (COLD) button 3 consecutive times
to change this selection.
Coins selected, debit disabled. Press the
lower-right (COLD) button 3 consecutive times to
change this selection.
With Card Payment System: Debit Card selected,
coins disabled. Press the lower-right (COLD) button
3 consecutive times to change this selection.
Enhanced Debit is self-selected when a Generation
2 card reader is installed in the washer/dryer.
The Ed option cannot be manually selected or
deselected.
Press the lower-middle (WARM) button once to
advance to next code.
h O0
L. 00
h PS
n. CE
n. 00
n. CE
PRICE SUPPRESSION OPTION
This option causes the customer display to show
"ADD" or "AVAILABLE" rather than the amount of
money to add. (Used mainly in debit installations.)
Not Selected "00."
Selected "PS."
Press the lower-right (COLD) button once
to change this selection.
Press the lower-middle (WARM) button once
to advance to next code.
CLEAR ESCROW OPTION
When selected, money held in escrow for 30
minutes without further escrow or cycle activity will
be cleared.
Not Selected "00."
Selected "CE."
Press the lower-right (COLD) button once to
change this selection.
Press the lower-middle (WARM) button once
to advance to next code.
Code Explanation
U. 00 PENNY INCREMENT OFFSET (WASHER}
U. 00 This represents the penny increment price offset
used with Generation 2 (Enhanced Debit) Models.
Choose from 0-4 pennies by pressing the lower-
left (HOT) button.
Press the lower-middle (WARM) button once
to advance to next code.
U.00 PENNY INCREMENT OFFSET (DRYER}
U.00 This represents the penny increment price offset
used with Generation 2 (Enhanced Debit) Models.
Choose from 0-4 pennies by pressing the upper-
left (COTTON/WHITES) button.
• Press the lower-middle (WARM) button once
to advance to next code.
AI. 00 PREWASH LENGTH (WASHER)
AI. 00 This is the number of minutes of PREWASH.
Choose 0 to disable the prewash or select between
2 and 7 minutes by pressing the lower-left (HOT)
button.
Press the lower-middle (WARM) button once
to advance to next code.
END of SET-UP PROCEDURES.
EXIT FROM SET-UP MODE
=Turn service switch key clockwise and remove or remove
manual set-up card.
37