Whirlpool CET8000AQ1 Installation Instructions Manual page 11

STACKED WASHER/ELECTRIC DRYER INSTALLATION
REQUIREMENTS
Stacked Washer/Electric Dryer Location
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire.
Selecting the proper location for your washer/dryer improves
performance and minimizes noise and possible washer "walk."
Your washer/dryer can be installed in a basement, laundry
room, or recessed area. See "Drain System."
Companion appliance location requirements should also be
considered.
iMPORTANT: Do not install or store the washer/dryer where
it will be exposed to the weather. Do not store or operate the
washer/dryer in temperatures at or below 32°F (0°C). Some
water can remain in the washer and can cause damage in low
temperatures. Proper installation is your responsibility.
You will need:
[] A water heater set to deliver 120°F (49°C) water to the
washer.
[] A grounded electrical outlet located within 6 ft. (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
[] Hot and cold water faucets located within 4 ft. (1.2 m)
of the hot and cold water fill valves, and water pressure
of 20-100 psi (137.9-689.6 kPa).
[] A level floor with a maximum slope of 1" (25 mm) under
entire washer/dryer. Installing the washer/dryer on soft floor
surfaces, such as carpets or surfaces with foam backing,
is not recommended.
[] A sturdy and solid floor to support the washer/dryer with
a total weight (water and load) of 450 Ibs (204 kg).
[] A floor drain under the bulkhead. Prefabricated bulkheads
with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.
Stacked washer/electric dryer installation clearances
[] The location must be large enough to allow the washer and
dryer doors to be fully opened.
[] Additional spacing should be considered for ease of
installation and servicing. The doors open more than 180 °.
The washer door is not reversible.
[] Additional clearances might be required for wall, door, and
floor moldings.
[] Additional spacing of 1" (25 mm) on all sides of the washer/
dryer is recommended to reduce noise transfer.
[] Companion appliance spacing should also be considered.
Recessed Area and Closet installation instructions
This washer/dryer may be installed in a recessed area or closet.
For recessed area and closet installations, minimum clearances
can be found on the warning label on the rear of the dryer.
The installation spacing is in inches and is the minimum
allowable. Additional spacing should be considered for ease
of installation, servicing, and compliance with local codes and
ordinances.
If closet door is installed, the minimum unobstructed air
opening in the top and bottom is required. Louvered doors
with equivalent air openings are acceptable.
The dryer must be exhausted outdoors.
+
48 in.2
(310 cm2)
+
Front
View
+
24 in?
(155 cm 2)
+
0
Closet
door
+
3"
(76 mr
+
11