Whirlpool CET8000AQ1 Installation Instructions Manual page 29

REVERSING DRYER DOOR SWING
NOTE: Dryer only. Washer door is not reversible. 4. Lift the inner door assembly off outer door assembly.
Remove the Door Assembly
1. Place a towel or soft cloth on top of dryer or work space to
avoid scratching of the surface.
2. Remove 3 of the 4 screws that hold the door hinge on the
front panel of the dryer. Partially loosen the remaining screw
with keyhole opening and lift the door off the screw.
\
5. Rotate outer door 180 °.
3. Lay the door assembly on a previously prepared flat surface
with the inside (inner door assembly) facing up, and remove
6 phillips-head screws to release outer door assembly from
inner door assembly.
1}
NOTE: It is important that you remove only 6 indicated screws.
Reverse Hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, without scratching inner door surface, and lift up
strip.
2. Remove the 4 screws that attach to inner door hinge.
29