Whirlpool CET8000AQ1 Installation Instructions Manual page 30

REVERSING DRYER DOOR SWING
3. Move hinge to other side. Reinstall 4 screws.
Reverse the strike
1. Use a small flat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the plugs, without scratching dryer surface, and lift
up strip.
4. Reinstall plug strips on opposite side of the inner door.
2. Remove the strike using a Phillips screwdriver.
5. Check for fingerprints on the glass. Clean if necessary.
Replace the Door Assembly
1. Place the inner door assembly inside the outer door
assembly.
3. Insert strike on the opposite side.
Reinstall the door
1. Partially insert the second screw from the top; then slide
the hinge onto this screw while hooking the hinge into the
front panel hole. Reattach door to dryer front panel with the
remaining three screws.
2. Reassemble the inner and outer door assemblies with the
6 screws.
30
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.