Console Operations; Console Overview - BLADEZ Jetbike GSX Owner's Manual

TIME
SPEED
DISTANCE
CALORIES (CAL)
KEY FUNCTIONS:
MODE: This key lets you to select and lock on to a particular function you want.
1. AUTO ON/OFF:
The system turns on when any button is pressed or when it receives a signal input from the speed
sensor. The system turns off automatically when the sensor has no signal input and no buttons
have been pressed for approximately 4 minutes.
2. RESET:
The unit can be reset by either replacing the batteries or pressing the reset button for 3 seconds.
3. MODE:
The computer can display one of 4 parameters; Time, Speed, Distance and Calories. By pressing
the MODE button repeatedly until the desired parameter is displayed. Press the MODE button
to move to the next parameter or loop through all parameters manually. There is also a SCAN
display. Press the MODE button until SCAN is flashing in the lower left corner. Under this
selection, the computer will automatically display each parameter one-by-one for 3 seconds in
the order of Time, Speed, Distance and Calories.
4. FUNCTIONS:
TIME: Press the MODE button until the pointer advances to TIME. The total working time
will be displayed.
SPEED: Press the MODE button until the pointer advances to SPEED. The speed will be
displayed.
DISTANCE: Press the MODE button until the pointer advances to DISTANCE. Each workout
distance will be displayed.
CALORIES: Press the MODE button until the pointer advances to CALORIES. The calories
burned will be displayed.
SCAN: The following functions will be displayed in the order shown: TIME-SPEED-
DISTANCE-CALORIES (repeat).
BATTERY: This monitor uses two AAA battery. If the display on the monitor is not clear, install
new battery.

CONSOLE OVERVIEW

00:00-99:59
0.0-99.9KM/H or ML/H
0.00-999.9KM or ML
0 -9999KCAL
17