Floppy Drive Connector (Cn3); Parallel Port (Cn4) - Advantech PCA-6009 User Manual

2.3 Floppy Drive Connector (CN3)

You can attach up to two floppy disk drives to the PCA-6009's on board
controller. You can use 3.5" (720 KB, 1.44 MB) drives.
The single board computer comes with a 34-pin daisy-chain drive con-
nector cable. On one end of the cable is a 34-pin flat-cable connector. On
the other end are two sets of 34-pin flat-cable connector (usually used for
3.5" drives). The set on the end (after the twist in the cable) connects to
the A: floppy drive. The set in the middle connects to the B: floppy drive.

2.4 Parallel Port (CN4)

The parallel port is normally used to connect the single board computer to
a printer. The PCA-6009 includes an onboard parallel port, accessed
through a 26-pin flat-cable connector, CN4. The card comes with an
adapter cable which lets you use a traditional DB-25 connector. The cable
has a 26-pin connector on one end and a DB-25 connector on the other,
mounted on a retaining bracket. The bracket installs at the end of an
empty slot in your chassis, giving you access to the connector.
17 Chapter 2