How To Change The Direction Of The Drain Hose - Haier XQB60-68 User Manual

How to change the direction of the drain hose

1.Dismantle the back cover of the washing
machine.
2.Put down the drain hose. Take off the
drainhose frame. As indicated in Figure
1, put thedrain hose into the cabinet.
Then stretch onehand into the cabinet
to nip the claw of the drain hose bush-
ing to remove the claw fromoriginal
position. Take off the drain hose bush-
ing with the other hand. (As indicated in
Figure 2 and 3).
Outer
drain
hose
Drain hose frame
Figure 1
Cabinet
Inner
Press
Drain hose
bushing claw
Press
The drain hose shall drain smoothly
1.The height of the drain hose shall be less than
10cm, or the drainage will not be smooth, and
cost such long time that the machine may stop
at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
Drain hose bushing
Figure 2
Outer
Drain hose
bushing
Take off
Figure 3
3.Dismantle the protecting cover of the
drain outletat the other side (method
the same as the bushing). Install the
bushing as per indicated in Figure 4.
4.Extend the drain hose from the other
side. Fix thedrain hose onto the base
frame with the drain hoseframe. (As
indicated in Figure 5)
Drain outlet
protecting cover
Drain hose bushing
Figure 4
5.Install the protecting cover of the drain
outlet at the other side as per indicated
in Figure 6.
Figure 6
4.If extra drain hose is needed, please make
separate purchase. The inner diameter of
the extra hose shall not less than 30mm,
and the length shall not exceed 1.5m.
If the extra is too long,cut it eigher A or at B point.
Figure 5