Trouble Shooting Answer To Question - Haier SIG100-97 Owner's Manual

Trouble shooting answer to question

(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department
or after-sale service department of our company. Do not repair it by yourself.
Phenomena
After the "reserve" is started,
it rings and the digital tube
displays "E0"
The draining does not work,
or the speed of draining is
too slow. The digital tube
displays "E1" and it rings.
It stops running during wash,
rinse or spin. The digital tube
displays "E2" and it rings.
It does not do water inlet or
the speed is slow (the water
level is not reached after 15
minutes). The digital tube
displays "E4" and it rings.
The machine does not act.
(the indicators are off.)
There's abnormal sound
inside the machine.
The water faucet leaks.
No water filling
The numeral tube shows
F2
Normal phenomena
Phenomena
Intermittent spin after spin starts
Spin is selected, yet the machine doesn't spin
While water filling in wash and rinse, the
pulsator pauses rotation
Small amount of water flows out upon the
washing machine is initially used
The machine stops when top cover is opened
during running.
The reason
The top lid is not closed
Is the drain hose blocked by
foreign material?
The top lid is not closed
Is the water faucet open or is
there water supply failure?
Is the water inlet valve is
blocked
Is there power failure?
Is the power plug loose?
Is the machine slanting?
Is there metal material inside
the washing machine?
Are the laundries slanting in
spinning?
Is the jointer of the water inlet
hose is loose or twisted awry?
If plug is inserted firmly?
If tap is turned on?
If Power On/Off and
Start/Pause is pressed?
Overflow alarm
Causes (explanations)
Adjust balance to avoid clothes offset
The program sets a drain time, spin starts
after a time.
To prevent splash during water filling.
This is residual water during factory perfor
mance test.
This is a normal fact. Due to the drum rotation,
an open cover alarm function is provided for safety.
16
How to settle
Close the top lid
Clean the foreign material. Open
and close the top lid once.
Close the top lid
Open the water faucet. Open
and close the top lid once.
Clean the water inlet valve.Open
and close the top lid once.
Use it when the power is on.
Insert the power plug tightly.
Level the machine properly.
Fasten the buttons and zipper
Re-order the laundries. Close the
top lid.
Fasten the jointer properly.
Insert the plug firmly
Turn on the tap
Press Power On/Off and
Start/Pause
Please contact the after-sales
service department.