Table of Contents
Advertisement
When you adjust the Pan control with a stereo-linked Channel selected, the Pan
LEDs show the width of the stereo spread that is currently set. Multiple LEDs light to
indicate the compression of the image from full stereo to mono.
The Mute and Solo Functions
Solo a Channel
While working with a mix, you may want to listen to a particular Channel by itself
to check a part, locate or solve a problem, select a pan location, etc. To do this you
can use the Solo mode. The Solo mode lets you listen to the selected Channel alone
without disturbing the rest of the mix.
Solo mode works on the currently selected Channel or Group. To use Solo mode,
first select the Channel you want to hear alone. Its red button LED should be lit. Now
press the S
button, found in the pair of buttons in the upper right corner of the
OLO
Personal Mixer. The Channel is now heard solo.
You can make changes to volume and panning when a Channel is in Solo mode. All
changes happen immediately. Consider Solo mode as a temporary state only. You
cannot save a Preset with a Channel in Solo mode.
Only one Channel, linked pair (or Group) can be in solo at a time. To exit Solo mode,
simply select another Channel or press the S
To select a different Channel for auditioning in Solo mode, remember that you must
first select a Channel and then press the S
Mute a Channel
The method used for muting Channels is similar to that used for the Solo func-
tion—first select the Channel, then perform an action. There are some differences,
however.
• You can mute as many Channels as necessary for your application.
• Channels that are muted can be saved as part of a Preset.
To mute a Channel, first select the desired Channel on the Personal Mixer. The red
Channel LED should be lit. Next, press the M
Channel's lower (yellow) LED will light to indicate that it is muted. Select any other
Channels that you want to mute and follow the same procedure to remove them from
the current mix.
Unmute a Channel
Once a Channel is muted, you can follow this simple procedure to clear the mute:
•
Select the muted Channel. (It should have the yellow LED in its button
button again to exit.
OLO
button to enter Solo mode.
OLO
button to silence the Channel. The
UTE
55
Advertisement
Table of Contents
