Table of Contents
Advertisement
Aviom A-16 Personal Monitor Mixing System
Note: A Channel that is already part of one Group cannot be part of any other
Group.
Making Changes to a Group
Once you have created a Group, you can edit it in a number of ways. You can add
or delete Channels from the Group, and change individual Channel volume and pan
settings.
To change a Group, start by selecting a Channel that is already part of a Group. All
Channel LEDs that are part of the Group will light. Press the G
the editing mode. The Group LED flashes.
Changing Channel Settings Within a Group
While editing a Group, you'll notice that one LED in each Group is lit solid while the
other LEDs are flashing. This solid LED indicates the Channel currently selected for
editing. You can change its volume and panning without affecting other components
of the Group. The changes you make to volume and pan affect only the selected
Channel, allowing you to change the relative balance of the individual components of
your Group. Changes can be made in real time.
To select a different Channel in a Group for editing, press one of the flashing LEDs
(don't double-click it). The new selection will light its LED solid, while the previ-
ously selected Channel will start to flash. Continue making changes as needed.
Remember, volume and pan changes only affect the Channel whose LED is lit solid.
Removing Channels From a Group
To remove a Channel from a Group, simply double-click the Channel that you
want to remove. The flashing LED will go out. To add other Channels to a Group,
double-click them. When you have double-clicked to remove all Channels that were
previously part of the Group you're editing, the Group will no longer exist. You need
at least two Channels to have a valid group.
Exit the Group edit mode by pressing the G
button will go out. This saves your changes to the Group.
Some points to note about Groups:
•
Up to three Groups can be created per Preset.
•
Groups are relative only to the Personal Mixer that they are created
on.
•
Groups you create on your Personal Mixer do not affect other Personal
Mixers being used in your system.
Remember that although you have edited and saved changes to your Group, you must
58
button again. The LED in the Group
ROUP
button to enter
ROUP
Advertisement
Table of Contents
