Table of Contents
Advertisement
Aviom A-16 Personal Monitor Mixing System
available for editing.
On the A-16CS Control Surface you can change
•
Volume
•
Panning for mono channels
•
Spread for stereo channels
•
Mute status
•
Grouping
In addition to these changes, you can use Solo Mode to audition your edits to a
Channel while all other Channels are temporarily silenced.
Volume and Pan Control
When you change the volume of a Channel on the Personal Mixer, the LEDs in the
Volume section of the mixer surface will indicate the level in real time. There are
twelve LEDs in the Volume indicator, each capable of displaying two levels, for a
total of twenty-four visible lighted steps.
When a Channel is selected, the current volume is instantly indicated on the LEDs.
When no LEDs are lit, Channel volume is at its minimum setting.
To make changes to a Channel:
• Select a Channel by pressing its numbered button—the upper LED
will light.
• Rotate the V
to lower the volume
• While the Channel is still selected, you can also change the Pan
setting. Rotate the P
Channel in the stereo field.
Pan LEDs
The Pan indicator is made up of five LEDs. The center LED is green. The LEDs on
either side of center are red. As you turn the P
combinations to provide the maximum number of position indicators with the fewest
number of lamps. At either end of the display only one LED will be lit to indicate that
38
knob to the right to increase the volume, to the left
OLUME
knob left or right to change the position of the
AN
Pan and Volume Controls
knob, the LEDs will light in various
AN
Advertisement
Table of Contents
