Table of Contents
Advertisement
Installing the A-16T or A-16R
in a Rack
The A-16T Transmitter and A-16R Personal Mixer are designed to be installed in a
standard 19-inch audio equipment rack. This design is both for easy transportation
of the units and for protection. Each unit takes up one standard rack space (19 inches
wide by 1.75 inches high). Optionally, you can place the units on a table top or other
flat surface such as a shelf.
The rack ears on each side of the device are designed to support the weight of the
A-16T or A-16R without additional hardware. Each rack ear contains holes for two
screws per side. Always support the unit with all four screws.
To rack mount the A-16T Transmitter or A-16R Personal Mixer, position it in the
equipment rack at the desired location. Use standard rack-mounting screws (10-32
size) to attach the unit to your rack hardware. Tighten all four screws firmly, but
avoid overtightening.
You may want to use non-metallic washers between the rack-mounting screws and the
device's finished surface to avoid marring the painted finish on your Aviom products.
Always allow adequate ventilation for devices mounted in equipment racks. Avoid
placing your A-16T and/or A-16R directly above or below other rack-mounted gear
that produces high levels of heat, such as power amps.
Channel Labels
For writing channel information or names on the A-16R Personal Mixer (or A-16CS)
label surface or "scribble strip", we suggest using a china marker or other easily
removed marking device. A china marker is designed for marking on plastic, metal,
glass, wood, and paper. These are available at most office supply outlets. Avoid the
use of permanent markers.
Mixer Label Strip
To clean the label writing area on the A-16R Mixer, use a soft clean cloth to remove
most types of temporary marking material. For difficult-to-remove types of marking
devices, a cotton swab moistened with a drop of rubbing alcohol can be used. Use the
minimum amount possible to remove the writing.
13
Advertisement
Table of Contents
