Table of Contents
Advertisement
When a Channel is selected, the current volume is instantly indicated on the LEDs.
When no LEDs are lit, Channel volume is at its minimum setting.
To make changes to a Channel:
• Select a Channel by pressing its numbered button—the upper LED
will light.
• Rotate the V
the left to lower the volume. The Volume LEDs indicate the current
level.
• While the Channel is still selected, you can also change the Pan
setting. Rotate the P
Channel in the stereo field.
Pan LEDs
The Pan indicator is made up of five LEDs. The center LED is green. The LEDs on
either side of center are red. As you turn the P
combinations to provide the maximum number of position indicators with the fewest
number of lamps. At either end of the display only one LED will be lit to indicate that
the Channel is panned full left or right.
When using linked channels ( stereo inputs), the LEDs light in different patterns,
using a pair of LEDs on either side of the display to indicate the width of the stereo
field. When the stereo image has been collapsed to mono, only the center green LED
will be lit. In this case the stereo input will be heard as mono.
Using Solo Mode
To listen to the Channel you're editing without hearing the rest of the current mix,
press the S
button. Make any necessary changes to the Channel. When finished,
OLO
press the S
button again or select any other Channel. Both methods will automati-
OLO
cally exit Solo Mode and return you to your current mix.
Note: The status of Solo Mode is not saved with a Preset.
knob to the right to increase the volume; rotate to
OLUME
knob left or right to change the position of the
AN
Pan and Volume Controls
knob, the LEDs will light in various
AN
29
Advertisement
Table of Contents
