Wps - Sapido GR-1142 User Manual


You will receive an IP address from Router A.
If you failed the WDS setting, please check you setting with refer to the list below.
Mode
LAN IP Address
Security
DHCP
Note 1: LAN IP address should be under the same segment but cannot be the same number.
6.2.3

WPS

This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using this
feature could let your wireless client atomically synchronize it's setting and connect to the
Access Point in a minute without any hassle. SAPIDO GR-1142 could support both Self-PIN
or PBC modes, or use the WPS button (at real panel) to easy enable the WPS function.
PIN model, in which a PIN has to be taken either from a sticker label or from the web
interface of the WPS device. This PIN will then be entered in the AP or client WPS device to
connect.
PBC model, in which the user simply has to push a button, either an actual or a virtual one,
http://www.sapido.com.tw/
Router A
Router
Set the same segment as the
router B(Note 1)
Example :192.168.1.1
Set the same security as
Router B
Enable
68
Router B
AP
Set the same segment as the
router A(Note 1)
Example :192.168.1.2
Set the same security as
Router A
Disable
User Manual v1.0.0