Installation And Adjustment - Haier HWM70-928NZP User Manual

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
Install the inner cover component
1. Open the top lid of the washing machine.
2. Put the inner cover component on the outer tub cover, aiming the inner cover shaft to
the installation hole of the corresponding outer tub cover shaft groove.
3. Firstly insert the inner cover shaft of one side into the corresponding outer tub cover
shaft groove, then push the another inner cover shaft into the corresponding outer
tub cover shaft groove. Please install to designated position to guarantee there are
no dropping or abnormal sound in opening and closing of the inner cover, and the
operation shall be smooth. Do not dismount the inner cover component after washing.
Figure 1
Inner cover component
Outer tub cover
Install the bottom plate
After you open the package, please lean the washing machine gently down on soft items
(like the towel cloth, blanket, etc. ).
Install the bottom plate to the bottom of the machine with the eight screws by a cross
screwdriver, then lift the machine up gently. See to the figure:
6
I enlarged view
Inner cover shaft
Outer tub cover shaft groove
Front
Back
Soft items
Bottom plate
Figure 2
II enlarged view
Outer tub cover shaft groove
Two claws at the bottom
cover shall be inserted in
two bar-shaped holes in
the stand. Make sure the
claws are firmly in place.
Fasten the bottom plate
to base frame with one
screw.
Inner cover shaft