Trouble-Shooting Answer To Question - Haier HWM70-928NZP User Manual

Trouble-shooting answer to question

(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes.Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department
or after-sale service department of our company. Do not repair it by yourself.
Phenomena
The digitron displays E0.
The drainage cannot work,
or is too slow. The digitron
displays E1.
It stops running in midway.
The digitron displays E2.
The safety switch acts, and
the spinning cannot work. The
digitron displays E3.
The water filling does not
work, the digital displays E4.
The digitron displays E6.
The machine
Not wash
does not act
Not spin
The water faucet leaks
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
● The spinning is intermittent when it starts
● The wash procedure is paused.
● Push the SPIN button to select SPIN, but
it doesn't work.
● The pulsator pauses during water inlet in wash
and rinse.
● There may be some water flowing out of the
drain hose in the first use of the machine.
18
The reason
● The top lid is opened during
reserve procedure.
● Is the drain hose put down?
● Is the drain hose blocked?
● The top lid is not closed.
● Are the laundries put slantingly?
● Is the machine slanting?
● Is the water tap opened, or is there
water supply failure?
● Is the water inlet valve blocked?
● Is the water pressure too low?
● The water level sensor is bad.
● Is there power failure?
● Is the power plug inserted tightly?
● Is the water level reached preset
position?
● Is the power plug inserted tightly?
● Is the top lid closed reliably?
● Are the laundries set flat?
● Is the jointer screw of the water
inlet hose is loose or twisted awry?
● Is the machine slanting?
● Are the laundries put slantingly in
spinning?
● Are there any foreign materials?
● Is the screw of the jointer of water
inlet hose loose or awry?
● Balance the laundries to avoid slanting.
● The cloth sensor is checking the cloth, it will add
water after 48 seconds.
● The program is setting the drain time. Some time
is needed before it starts spinning.
● It is to avoid splashing during water inlet.
● It is the water remained in the factory inspection of
performance.
How to settle
► Close the top lid.
► Put down the drain hose. Open
and close the top lid once.
► Clean the foreign material. Open
and close the top Lid Once.
► Close the top lid.
► Reorder the laundries. Close the
top lid.
► The machine will start running
after 10 seconds of being placed
horizontally.
► Open the water tap. Open and
close the top lid once.
► Clean the water inlet valve. Open
and close the top lid once.
► Use after the water pressure is
normal.
► Please contact the after-sales
service department.
► Please use it when there's power
supply.
► Insert the power plug tightly.
► Fill water to the preset position.
► Insert the power plug tightly.
► Close the top lid.
► Set the laundries flat.
► Fasten the jointer screw properly.
► Adjust the machine to be even
► Reorder the laundries and close
the top lid.
► Remove the foreign materials.
► Fasten the screw of the jointer
properly.
Explanation