I/O Device Configuration - General Dynamics Itronix GD6000 User Manual

GD6000 User Guide
Field
Fan
Audio
Back-light
Brightness
Wireless
Radios

I/O Device Configuration

This configuration option allows you to assign Serial and Parallel port settings.
Field
Serial Port A
Base I/O address:
Interrupt:
Serial Port for Touch Screen
Interrupt:
Serial Port for GPS
Interrupt
General Dynamics Itronix | 72-0136-005
Setting Function
Off The fan is disabled. Heat management is then controlled solely through throt-
tling.
On The fan functions normally.
o Volume is set to 0 across suspend/resume and boot. Use the existing audio
FF
function keys to restore volume.
On Audio is preserved across suspend/resume and boot. The default volume level
is set to mid-range.
o
Brightness is set to 0 across suspend, resume and boot. Fn+F1 restores bright-
FF
ness to the value it was set to before suspend. Additionally, Fn+F7 increases
display brightness gradually. Fn+F6 decreases brightness gradually.
On Display brightness is preserved across suspend/resume and boot. It is restored
to default when the brightness level is set at 0. The default level is mid-range.
o All wireless devices are set to off during a suspend/resume or boot. The radio
FF
on/off button can be used to manually turn the radios on or off.
On The radio on/off button functions normally and radio device power states are
held though suspend/resume and boot.
Setting
e
naBled
Disabled
3F8
2F8
3E8
2E8
IRQ3
irq4
e
naBled
Disabled
irq6
e
naBled
Disabled
irq5
IRQ7
Customizing Your BIOS Settings
Function
If enabled, user can configure serial port A.
Sets the base I/O address for this serial port.
Sets the interrupt request of this serial port.
If enabled, user can configure serial port C.
Sets the interrupt request of this serial port.
If enabled, user can configure serial port A.
Sets the interrupt request of this serial port.