Configuration; Default Ethernet Settings - HP StorageWorks MSL5000 Series User Manual

Optional Fibre Channel Card

Configuration

For detailed configuration information, refer to the StorageWorks by Compaq
Network Storage Router User Guide available on the MSL5000 Series Documentation
CD or on the HP website at: http://www.compaq.com/storage/tape_index.html.
Before attempting to configure the Fibre Channel board, a basic understanding of
Fibre Channel and SCSI devices is recommended. For information on SCSI standards,
refer to publications from X3T10 committee of ANSI (American National Standards
Institute). For more information on Fibre Channel standards, refer to publications
from the X3T11 committee of ANSI. To purchase approved American National
Standards and Technical Reports, contact ANSI at (212)642-4900.

Default Ethernet Settings

The basic factory default values are:
• IP address: http://1.1.1.1/
• Subnet mask: 255.255.255.0
• Gateway address: 0.0.0.0
• User name: root
• Password: password
HP recommends that you change these values from the defaults.
All settings within the configuration are pre-set with default values. These values are
set to allow the Fibre Channel card into most HP environments with little or no
configuration changes.
After changing the basic default values listed above, carefully consider any additional
configuration changes.
After the initial configuration is established, HP recommends backing up the
configuration to an external file. If needed, during a recovery process, this file can then
be restore back onto the router.
F–4 MSL5000 Series Library User Guide