Page 2
Desconexión de alimentación eléctrica • Para desconectar con seguridad la acometida de alimentación eléctrica al equipo, desenchufar todos los cables de alimentación use. In no event will Extron Electronics be liable for direct, indirect, or consequential en el panel trasero del equipo, o desenchufar el módulo de alimentación (si fuera Este símbolo se utiliza para advertir al usuario sobre...
Receiver Considerations ............2-13 Skew Delay Compensation ..........2-14 Appendix A • Reference Information ......A-1 Specifications ................A-2 MTP transmitter and compatible devices ......A-5 Included parts.................A-5 Cables..................A-6 Connectors................A-6 Decora Template Dimensions ..........A-7 MTP U T A D • Table of Contents...
MTP U T A D Chapter One Introduction About the Universal MTP Decora Transmitter ® Twisted Pair (TP) Cable Advantages All trademarks mentioned in this manual are the properties of their respective owners. MTP U T A D • Table of Contents...
Transmitter Twisted Pair Cable Advantages ® The Extron MTP U T A D is a mini twisted pair (MTP) Twisted pair (TP) cable is much smaller, lighter, more flexible, transmitter, in a two-gang Decora form factor, that is fully and less expensive than coaxial cable. These TP products make compatible with all MTP video and audio receivers and cable runs simpler and less cumbersome.
Page 7
Resolutions marked with an asterisk (*) in this table have the same range specifications at 75 Hz. Skew Compensation Extron recommends using at least 25 feet (7.6 m) of TP cable between the transmitter and the first receiver. MTP U T A D • Introduction...
Installation " (63.5 mm) The MTP U T A D transmitter can be installed in a two-gang electrical wall box with a Decora wall plate cover (supplied). The installation must conform to national and local electrical codes and to the wall plate’s size requirements.
Connect a video and an audio source to the front panel (see "Front panel features", later in this chapter, for connector details). MTP U T A D • Installation and Operation MTP U T A D • Installation and Operation...
15-pin HD connector for buffered loop-through of the high or connector, which consists of a tip and sleeve. low resolution video input on the Computer Input connector ) only. MTP U T A D • Installation and Operation MTP U T A D • Installation and Operation...
S-video The front panel Contact DIP switch ( , on page 2-8) must be on (up) for contact closure to be available. MTP U T A D • Installation and Operation MTP U T A D • Installation and Operation...
The two power cord wires must be kept separate while the power supply is plugged in. Remove power before wiring. MTP U T A D • Installation and Operation 2-10 MTP U T A D • Installation and Operation 2-11...
Page 13
Side Pins: 12345678 T568A T568B Video input selected Audio input Wire color Wire color Component S-video Composite Stereo audio White-green White-orange Red+/V. sync+ R-Y+ Chroma (C)+ Reserved Green Orange Red–/V. sync– R-Y– Chroma (C)– Reserved White-orange White-green Mono audio+ Blue Blue Green+ Luma (Y)+...
100 feet from the transmitter when the Pre-Peak switch is on. For daisy-chained units, any receiver in the chain closer than 350 feet may experience some form of over-peaking when the Pre-Peak switch is on. MTP U T A D • Installation and Operation 2-13...
Switch to Extron Enhanced Skew-Free A/V UTP cable. • Add a skew compensation cable equal to the length of pair skew to the receiver’s output. A ppendix A Reference Information Specifications Part Numbers Decora Template Dimensions MTP U T A D • Installation and Operation 2-14...
Horizontal frequency....15 kHz to 130 kHz Vertical frequency......30 Hz to 150 Hz Return loss........<-30 dB @ 5 MHz DC offset (max. allowable)... 250 mV MTP U T A D • Reference Information MTP U T A D • Reference Information...
External power supply ....100 VAC to 240 VAC, 50-60 Hz, external; A complete transmission system requires a transmitter to 12 VDC, 1 A, regulated (MTP U T A D) and at least one MTP receiver. Power input requirements ... 12 VDC, 0.5 A Transmitter Part number Temperature/humidity ....
To install a 2-gang MTP U T A D directly into furniture or Panel wall, cut along this line. Figure A-1 — Decora Template Dimensions MTP U T A D • Reference Information MTP U T A D • Reference Information...
Page 19
Reference Information, cont’d MTP U T A D • Reference Information...
Need help?
Do you have a question about the MTP U T A D and is the answer not in the manual?
Questions and answers