Oce VarioLink 4522c User Manual page 35

3.2 Configuring the basic settings
Settings
Staple/Punch
Staple/Punch
Fold/Bind
VL4522c/VL5522c/VL6522c
Staple:
Copies can be bound with a staple in the corner or with two staples.
Punch:
Copies can be fed out hole-punched.
The number of punched holes varies depending on the country (area)
where this machine is used. For details, contact your service representa-
tive.
Position Setting Select the desired staple or hole-punch position.
•
•
•
Half-Fold Select this setting to fold copies at the center in
half before feeding them out.
Center Staple & Fold Select this setting to staple copies at the center
before feeding them out.
Tri-Fold Select this setting to fold copies in three before
feeding them out.
1 1
[Auto]:
The staple or hole-punch position is automat-
ically set either at the top or at the left.
A staple or punch position along the long side
of the paper is selected if the original length is
11-11/16 in (297 mm) or less.
A staple or punch position along the short
side of the paper is selected if the original
length exceeds 11-11/16 in (297 mm).
If [Auto] is selected for the staple or hole-
punch position, load the original with the top
toward the back of the machine.
If desired, press [Original Direction], and then
specify the direction in which the original is
loaded.
3
3-12