Removing Misfeeds - Oce cm4010 Troubleshooting Manual

REMOVING MISFEEDS

This chapter explains what to do when a paper misfeed occurs in the machine.
Removing misfeeds
When a paper misfeed occurs, "A misfeed has occurred." appears in the touch panel and printing stops. In this event,
touch the [Information] key in the touch panel. When the key is touched, instructions for removing the misfeed will
appear. Follow the instructions. (The approximate locations of possible misfeeds are indicated by blinking
shown below.)
Caution
The fusing unit is hot. Take care not to burn yourself when removing a misfeed.
• When removing misfed paper, do not touch or damage the transfer belt.
• Carefully pull the paper out without tearing it.
• A misfeed may have occurred inside the machine. Check carefully and remove the
misfeed.
• If the paper tears, be sure to remove all pieces from the machine.
Paper misfeed illustrations
If you require more information when reading the instructions in the touch panel, see the paper misfeed illustrations on
the following pages. Refer to the illustration below and then go to the appropriate illustration (1 to 14) for your situation.
☞
(1)-(4): page 4, (5)-(10): page 5, (11)-(14): page 6
(11)
(14)
A misfeed has occurred.
Full Color
Turning M/C off now causes data loss.
Color Mode
Job Detail
Settings
Auto
Exposure
Information
100%
Copy Ratio
(12) (13)
Misfeed location
2-Sided Copy
Output
Special Modes
File
Quick File
(1) (2) (3)
(8) (9)
0
Fusing
area
Transfer
belt
(10)
(4)
(5)
(6)
(7)
marks as
3