Arming The System - Honeywell LYNX User Manual

SECURIN SECURING THE PREMISES SECURIN SECURIN G THE PREMISES G THE PREMISES G THE PREMISES

Arming the System

Arming in Stay Mode
Use this mode when you are staying home, but expect someone to use the entrance door
later. Close all protected perimeter windows and doors before arming. The green READY
indicator on the control should be lit if the system is ready to be armed. When armed in
STAY mode, the system will sound an alarm if a protected door or window is opened, but you
may otherwise move freely throughout the premises. Late arrivals can enter through the
designated entrance door without causing an alarm, but they must disarm the system within
the entry delay period or an alarm will occur. If Quick Arm was programmed by the installer,
you do not need to enter the security code to arm the system. The security code must always
be used to disarm the system, however.
The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm
the system. In addition, if the system is armed by pressing via Quick-Arming, neither the
Babysitter Code nor Installer Code can disarm the system.
Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Ready To Arm
Arm the system in Stay mode
Enter Code:
Cancel
Zones System
Message Phone
More
5000-100-006-V0
1 2 3
4 5 6
7 8 9
Clear 0
5000-100-137-V0
– 18 –
1. Select the Arm Stay icon, the system will
beep once and display a keypad.
2. Enter a valid User Code.
OR
If Quick Arm has been enabled, select the
"Quick Arm" icon.
The system will beep three times and
announce "Armed Stay Exit Now" . The exit
delay screen
programmed the display will count down
the time remaining in the exit delay.
Note: If a valid user code is not entered or the
Confirm icon has not been selected within
10 seconds, the system will return to the
"home" screen and it will not be armed.
will be displayed. If