Bypassing Protection Zones - Honeywell LYNX User Manual

Bypassing Individual Zones
The Bypass feature can be used when you want to intentionally arm your system with one or
more zones unprotected. Bypassed zones are unprotected and will not cause an alarm when
violated while your system is armed. All bypasses are removed when an Off sequence
is performed. Bypasses are also removed if the arming procedure that follows the bypass
command is not successful. The system will not allow panic, fire or CO zones to be
bypassed.
Bypassing zones
Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Not Ready To Arm - Fault
2. Front
Door
FAULT
Bypass All
Clear
Faulted
Bypasses
Not Ready to Arm - Fault
Bypass Selected Zones
Enter Code:
Cancel
Zones System
Message Phone
More
5000-100-006-V0
Select
Bypass
Fault
5000-100-141-V0
1 2 3
4 6
5
7 9
8
Clear
0
5000-100-067-V0
SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES

Bypassing Protection Zones

1. With the system in the disarmed state,
select the "Zones" icon. The system displays
the Zones/Bypass screen.
2. Select the zone(s) that you wish to bypass
and then select "Bypass" OR if programmed,
the "Bypass All Faulted" button allows you to
bypass all faulted zones (excluding Panic,
Fire or CO zones). The system displays a
keypad.
3. Enter a valid Code. The system returns to
the Bypass screen and the zone(s) that are
bypassed will be displayed.
4. Select the
screen.
5. Arm the system normally. See ARMING
THE SYSTEM section for procedure
– 27 –
icon to return to the home