Programming Devices - Honeywell LYNX User Manual

General Information
The Device programming option can be used to trigger device, send Follow-Me or E-mail
messages of system events. Up to 16 devices can be programmed. Devices 1 through 8 are
used for Triggers and Follow-Me Messages and Devices 9 through 16 are used for E-mail
events. Check with your Installer to see which options are available to you.
The following options are programmed in this section:
Programming Field
Device 1 -16:
Name:
Action:
Start Zone Type:
Stop Zone Type:
Start System Operation:
Stop System Operation:
Zone Number Operation:

Programming Devices

Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Ready To Arm
Program the system
Enter Code:
Cancel
Select Device 1 -16
Name the device
Select the action required for the device
Select Zone Type to trigger event
Select Zone Type to stop event
Select System Operation to trigger event
Select System Operation to stop event
Select Zone Number to trigger event upon fault, trouble or alarm
as selected.
Tools
Settings
Back
5000-100-007-V0
1 2 3
4 6
5
7 9
8
Clear
0
5000-100-009-V0
Programming Devices
Action
1. With the system in the disarmed state, select
the "Tools" icon from the second page of the
Home Screen. The system displays the Keypad
screen.
2. Enter your 4-digit Master User Code. The
system displays the Master User programming
screen.
– 45 –
USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS