Table of Contents
Advertisement
Master/Slave
Mode
Reset
Software
Factory
Defaults
Page 16 of 20
The Master/Slave mode allows a single Intimidator™ FX 350 unit (the master) to control
the actions of one or more Intimidator™ FX 350 units (the slaves) without a DMX
controller. The master unit operates in either Automatic or Sound-Active mode, while the
slave units operate in Slave mode. Once set and connected, the slave units will operate
in unison with the master unit.
Configure the units as described below.
Slave units:
1.
Press <MENU> repeatedly until SLAv shows on the display.
2.
Press <ENTER> to accept and Son will show on the display.
3.
Set the DMX address to 001.
4.
Connect the DMX input of the first slave unit to the DMX output of the master unit.
5.
Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6.
Finish setting and connecting all the slave units.
Master unit:
1.
Set the master unit to operate in either Automatic or Sound-Active mode.
2.
Make the master unit the first unit in the DMX daisy chain.
·
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
To reset the software on the Intimidator™ FX 350, do the following:
1.
Press <MENU> repeatedly until rESt shows on the display.
2.
Press <ENTER>. The product will reset all settings in the software.
To load the factory defaults on the Intimidator™ FX 350, do the following:
1.
Press <MENU> repeatedly until LoAd shows on the display.
2.
Press <ENTER>. The product resets to factory default settings.
Intimidator™ FX 350 User Manual Rev. 1
Advertisement
Table of Contents
