Changing The Needle; Changing The Presser Foot; Presser Foot Pressure; Presser Foot Lever - Husqvarna Viking Scandinavia 100 User Manual

Changing the Needle

!
Turn off the main switch
1. Loosen the screw in the needle clamp
with the screwdriver.
2. Remove the needle.
3. Push up the new needle with the fl at side
away from you until it will go no further.
4. Use the screwdriver to tighten the screw
properly.
Always use needles of system 130/705H.

Changing the Presser Foot

!
Turn off the main switch
1. Make sure that the needle is in the highest
position. Pull the presser foot towards
you.
2. Line up the cross pin on the foot between
the spring and the presser foot ankle.
Press back until the foot snaps into place.

Presser Foot Pressure

The presser foot pressure is adjusted with
the dial on the front of the machine. Normal
setting is 4. The higher the number the more
pressure on the fabric. Knit and Soft fabrics
should be sewn at low pressure.

Presser Foot Lever

The presser foot is raised and lowered with
the presser foot lever. The presser foot must
be lowered when sewing.
By raising the presser foot lever as far as it
goes and holding it there, the lift height of
the presser foot can be increased by sev-
eral millimeters. This is useful when sewing
heavy materials.
Procedures
11