Changing The Needle Plate; Inserting The Bobbin; Changing The Presser Foot - Husqvarna Viking SAPPHIRE 9650Q User Manual

CHANGING THE NEEDLE PLATE

1. Remove the presser foot and slide off the bobbin
cover.
2. Make sure that the feed teeth are lowered. Place the
screwdriver under the needle plate as shown in the
picture and gently turn the screwdriver to pop off the
needle plate.
3. With feed teeth lowered, place the needle plate so that
it fits into the notch at the back (D). Press the needle
plate down until it clicks into place. Slide on bobbin
cover.

INSERTING THE BOBBIN

1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case. The bobbin only
drops in one way; with the logo facing up. The thread
unreels from the left of the bobbin. The bobbin
will then rotate counter-clockwise when you pull the
thread.
3. Place your finger on the bobbin to keep it from
turning as you pull the thread firmly to the right and
then to the left into the tension spring (C) until it
"clicks" into place.
4. Continue threading around (D) and to the right of the
thread cutter (E). Slide on the bobbin cover (F). Pull
the thread to the left to cut (G).
Note: The bobbin cover can be used as a magnifying glass to make
threading easier.

CHANGING THE PRESSER FOOT

1. Make sure that the needle is in the highest position.
Pull the presser foot down and towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle.
3. Push the foot into the clip until the foot snaps into
place.
2:8
1
2
D
3
1
3
D
C
E
2
4
G
F