Step 4, Remove Wood Base, Install Leveling Legs; Brace - Monogram ZBD6920D00SS Installation Instructions Manual

Installation Instructions
STEP 3 CHECK DOOR BALANCE
• With dishwasher on the wood skid, check the door
balance by opening and closing the door.
• If the door drops when released,increasethe spring tension.
If the door riseswhen released,decreasethe tension.
• There are two types of counter balance and therefore two
methods of adjustment. Identify which counter balance is
present and adjust tension accordingly. Pleasenote: if
there are 3 holes on the cable, usethe cable to adjust;
if there is one hole on cable use the tub leg to adjust.
Tgpe 1 - One-hole cable
Adjust tension by moving spring hook to one of the three
holes on the tub leg.
Figure H
One Hole
Tgpe 2 - Three-hole cable
Adjust tension by moving spring hook to one of the three
holes on the pulley cable.
\
Decrease
Figure I Increase Tension
Tension
After adjusting spring tension, open and close the door to
make sure the door operates smoothly. If the door is hard
to move or if the spnng cable binds, check the routing of
the spring cable. The cable should be routed between the
shoulders of the pulley cable roller. If the cable is off the
roller: latch door, remove spring tension and route the
cable between the shoulders of the roller. See Figure J.
Figure J _". ' _ "
Pulley
Correct Spring Incorrect Spring
Cable Routing Cable Routing
STEP 4 I REMOVE WOOD BASE, INSTALL
LEVELING LEGS
IMPORTANT-Do
not kick off wood base!
Damage will occur.
• Hove thedishw(]sher closeto the inst(]ll(]tion Ioc(]tion (]nd I(]y
it on its b(]ck.
• Remove the four levelinglegson the underside of the wood b(]se
with (in (]djust(]ble wrench or 15/16"socket.
• Disc(]rdb(]se.
Figure K
/
•Screwlevelinglegsb(]ckinto the dishw(]sher f r(]me(]pproxim(]tely
1/8" from fr(]me(isshown.
STEP 5 I REMOVE TOEKICK
• Remove the 2 toekick
screws(]ndtoekick.
Set(]sidefor use
in Step24.
......... Toekick
........... Remove 2
..... Toekick Screws
Figure L
STEP 6 I REMOVE TOEKICK BRACE
Skipthis step if your modeldoesnot havea soundupgrade kit.
If your modeldoeshavea soundupgrade kit, this brace must
be removed.
• Remove the 2 toekick
br(]cescrews(]nd
toekickbr(]ce.
Disc(]rd br(]ce
(]ndsetscrews
(]sidefor usein
Step23.
Figure
M
Remove 2
:: Toekick Screws