23, Install Sound Upgrade Kit If Equipped - Monogram ZBD6920D00SS Installation Instructions Manual

Built-in dishwashers
Table of Contents

Advertisement

Installation Preparation
PREPARE DRAIN PLUMBING
Drain Requirements
• Drain hose must not exceed 10 feet in length.
• A high drain loop or air gap is required. See below.
Drain Method
The type of drain installation
depends on the
following:
• Do local codes or ordinances
require an air gap2
• Is waste tee less than 18" above the floor2
If the answer to either question
is yes, an air gap
must be used. Refer to Method 1 (Figure C) in the
adjacent
illustrations.
If both answers are no, either an air gap or high drain
loop may be used. Refer to Method 1 (Figure C) or
Method 2 (Figure D)in the adjacent
illustrations.
NOTE: Drain hose elevation
must not exceed 48".
Special consideration
for a dishwasher
installed
on a elevated
platform
If the dishwasher
is installed on an elevated platform,
a high drain loop of at least 32" above the platform
must be provided
in addition
to the air gap or drain
loop requirement
determined
above. This is necessary
for proper drain performance.
A,,-^,
,-,-,,,_,,,
_ll, k,,/_U/IUl_l:
An airgap MUST BE USED if
the drain hose is connected
to waste tee or disposer
lower than 18" above the floor level. Failure to
provide the proper drain connection
height with an
air gap or 32" minimum
high drain loop will result in
improper
draining of the dishwasher,
which may
cause damage.
Cabinet
Preparation
for drain line
Drill a 1-1/2" dia. hole in the cabinet wall within the
shaded ureas shown in Figure A for the drain hose.
Make sure there are no sharp edges. The drain hose
will be passed through
this hole and connected
to
the drain in a later step.
Method 1--Air Gap with Waste Tee or Disposer
Waste Tee Installation
Disposer Installation
Figure C
Method
2--"High
Drain Loop" with Waste Tee or
Disposer
Use the drain hose hanger included in the installation
kit to attach the drain hose to the underside of the
countertop. Attachment will be made in a later step.
Install waste tee or disposer and the air gap according
to the manufacturer's instructions.
Waste Tee Installation
Figure D
Disposer Installation
IMPORTANT-
When
connecting drainline to disposer,
check to be surethat drainplug has
been removed. DISHWASHER
WILL
NOT DRAIN IFPLUG ISLEFT IN PLACE.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents