Monogram ZBD6920D00SS Installation Instructions Manual page 13

Installation Instructions
STEP 18 CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through
1" diameter inlet ports on the air gap, waste tee or
disposer.
• Determine size of inlet port.
• Cut drain hose connector on the marked line,
if required, to fit the inlet port.
Figure FF
j Cutting Line
IMPORTANT:Do not cut corrugc4ed
portion of hose
• If a longer drain hose is required, and you did not
purchase 10' long GPF10L drain hose, add up to
3-1/2' of length for a total of 10' to the factory
installed hose. Use 5/8" or 7/8" inside diameter
hose and a coupler to connect the two hose ends.
Hose Clamp
Coupler
\
Hose Clamp
Secure the connection with hose clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10' FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer
using the previously determined method.
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
Method 1--Air gap with waste tee or disposer
Insert the drain hose into the air gap as shown.
Waste Tee Installation Disposer Installation
Figure HH
Method 2--High Drain Loop with the Waste Tee
or Disposer
Route the drain hose of the dishwasher to a
minimum height of 32" from the floor with the
supplied hanger as shown.
Fasten to underside
of countertop
...... -_¢!"
Fasten to underside
of countertop
f-S;')
Waste Tee Installation
FigureII
Disposer Installation
IMPORTANT-
One of the above methods
must be used or dishwasher will notoperate
properly.
IMPORTANT- When
connecting drainline to disposer,
check to be surethatdrain plug
has been removed. DISHWASHER
WILL NOT DRAIN IFPLUG ISLEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
13