Advance Planning; Enclosure - Monogram ZBD6920D00SS Installation Instructions Manual

Installation Preparation
ADVANCE PLANNING
• These dishwashers are designed for versatility,
adaptable to virtually any installation.
• All models have a full-length door without
the traditional access panel.
• These dishwashers may be installed beneath
countertops of stone or other materials that will
not accept screws. No trim kit required.
PREPARE DISHWASHER ENCLOSURE
54-1/2" _+1//4"
Underside of
Countertop
to Floor
This Wall Area
be Free
Pipes or wires
Cabinets
Square
and
Plumb
/
,%
Floor MUST
be Even with
Room Floor
24"MJn.
Figure A
*Dishwasher models ZBD6900PII and ZBD8900PII require a 3/4" thick
custom panel and will be 24-3/4" deep.
• The rough cabinet opening must be at least 24"
deep, 24" wide and approximately 34-1/2" high
from floor to underside of the countertop.
• The back wall should be free of pipes or wires.
• Adjacent cabinets should be square and plumb
to ensure a good fit (Figure A).
• For a corner installation, allow 2" minimum
clearance between the dishwasher and the
adjacent wall.
• Plumbing and electrical service must enter
the shaded area.
• The dishwasher must be installed so that the drain
hose is no more than 10 feet in length for proper
drainage.
• Provide at least 28-3/8" in front of the dishwasher to
allow the dishwasher door to open fully (Figure B).
• IVlake sure the floor is level inside the opening and
even with the finished floor of the kitchen. This will
facilitate removal of the dishwasher at a later date
for service, if needed.
kWARNING
To reduce the risk of electric shock, fire,
or injury to persons, the installer must
ensure that the dishwasher is completely
enclosed at the time of installation.
Special consideration for a dishwasher
installed on a elevated platform
The elevated platform must be flat
and level.
• The dishwasher must be installed no
s4" more than 10 feet from a sink for proper
Adjustable
drainage.
to ss" The dishwasher must be fully enclosed on
the top, sides and back.
• The dishwasher must not support any part
of the enclosure.
Figure B
i
I
Countertop
CLEARANCES:In a corner
installation, provide atleast
2" clearance between the
dishwasher and the adjacent
cabinet, wall or other
appliance.
Provide at least 28-3/8" of
clearance in front of the
dishwasher (Figure B).
4