Step 15 Level Dishwasher - Monogram ZBD6920D00SS Installation Instructions Manual

Installation Instructions
STEP 14 SLIDE DISHWASHER INTO
FINAL POSITION (cont.)
• Front of door panel should be flush with face of cabinet.
• Carefully open and close the door to ensure that
the door panel does not catch or rub on the cabinet
frame. Refer to Figure V below.
• If the door catches or rubs on the frame, reposition and/
or level the unit (see Step 15) until the door moves freely
and does not contact the cabinet frame.
/
Correct
Alignment Door Catches on
Cabinet Frame
Figure V
Alignment
Special Considerations for Positioning
The controls on these models are designed to be
hidden by your countertop. Align the dishwasher as
shown in Figure W. Leave a 1/2" minimum gap between
the underside of the countertop and the top of the
dishwasher door as shown in Figure X.
Use the leveling legs to increase or decrease the amount
of gap between the controls and the countertop.
IMPORTANT-
Leave e 1/2" minimum
gap between the controls and the underside of the
countertop to prevent condensation end damage
to the control panel from screw heads.
Counterto
Figure W
Controls Hidden by
Countertop
1/2" l
Min.
Figure X
Countertop
/
/
Dishwasher Door
11
STEP 15 LEVEL DISHWASHER
IM PO RTANT - Dishwasher must belevel for
proper dish rack operation and wash performance.
• Make sure 1/2" minimum gap is maintained.
• Place level on door
to check that the
dishwasher is level
side to side.
Remove lower
rack, place
level on lower UseLevel
rack track inside
to Check
tub to check that Front t o
the dishwasher is
Back
level front to back.
Use Level
to Check
Side to
Side
Figure Y
• If the dishwasher is not level, adjust the four leveling
legs as illustrated in Figure Z.
• If adjustment to the right rear leveling leg is required,
access it by loosening the junction box bracket screw
(through the access hole) and rotate bracket clockwise.
i
Access Hole _ _..-_ Junction Box
S
Figure Z
• The dishwasher is properly leveled when the level
indicator is centered left to right and front to back.
The dishwasher door should close without hitting
the sides of the tub.
• Replace the lower rack when leveling is complete.
TIP: Avoid unnecessory service charges for poor wash
performonce end rock operation.
Pull the dish racks halfway out. They should remain
stationary. Open and close the door. The door should fit
in the tub opening without hitting the side of the tub. If
the racks roll on their own, or the door hits the side of
the tub, relevel the dishwasher.
I M PORTANT-
After leveling, verify thclt
the dishwasher is centered in the enclosure end the
door does not hit adjocent cabinets.