E-Mail - Planet ICA-530 User Manual

3.11 E-Mail

Using E-Mail function, user can send an e-mail with attached image file that has been shot
triggered with an external sensor or the built-in object detection function. The image file also
can be sent periodically.
Common
You may setup SMTP mail parameters for future event-message receiving such as object
detected or sensor activated.
E-Mail Enable: To enable or disable E-Mail function.
E-mail to: Type the receiver's e-mail address. Note: you can specify multiple recipient email
addresses at the time.
From: Type the sender's E-mail address. This address is used for reply e-mails.
Subject: Type the subject/title of the e-mail.
SMTP Server: Type the SMTP server name or the IP address of the SMTP server.
Port: Set port number of SMTP service.
Need Authentication: Select the authentication required when you send an e-mail.
User name: Type the user name for the SMTP server if Authentication is On.
Password: Type the password for the SMTP server if Authentication is On.
SMTP Test: Send a test mail to mail server to check this account is available or not.
On: if authentication is required when an e-mail is sent.
Off: if no authentication is required when an e-mail is sent.
50/68