Step 5, Connect Ductwork; Step 6, Connect Electrical - GE Monogram ZV750 Installation Instructions Manual

Installation Instructions
INSTALLATION -VENTED TO THE OUTSIDE
CONNECT DUCTWORK
• Remove shipping tape from the damper.
• Install ductwork, making connections
in the direction of airflow as illustrated.
• Push duct over the exhaust outlet and damper.
Airflow
Duct tape over
seam and
screw
-- Screw
-ACAUTION:
Do not use sheet metal
screws at the exhaust outlet connection. Doing
so will prevent proper dumper operation. Seal
connection with tape onlg.
• Secure joints in ductwork with sheet metal screws.
• Wrap all duct joints and the flange connections
with aluminized duct tape for an airtight seal.
_-1 CONNECT ELECTRICAL
Verify that power is turned off at the source.
-_WAR N ING:_f h ouse
wiring
isnot 2 -wire
with u ground wire, u ground must be provided
bg the installer. When house wiring is aluminum,
be sure to use U.L.-upproved untioxidant compound
and aluminum-to-copper connectors.
• Remove the junction box cover and the selected
knockout.
boxcover
• Secure the house wiring to the junction box with
a strain relief (not provided).
• Connect the white lead to the branch circuit white lead.
• Connect the black lead to the branch circuit black lead.
• Connect the green/gellow lead to the branch
circuit green lead or bare ground lead.
• Secure all the connections with wire nuts on each
electrical connector.
• Push the wires into the junction box and replace
the cover. Be sure the wires are not pinched.
• Secure the junction box cover with the 2 original
screws.
12